FUEL PUMP-TO-FUEL FILTER FUEL LINE - CONTINUED
For more information on how to clean parts, go to General Maintenance Instructions
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes
and don't breathe vapors. Do not use near open flame or excessive heat. The flashpoint
is 1000F to 1380F (380 to 590C). If you become dizzy while using cleaning solvent, get
fresh air immediately and get medical aid. If contact with eyes is made, wash your eyes
with water and get medical aid immediately.
a. Clean in drycleaning solvent.
b. Using clean, dry rags, wipe dry.
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-137).
Replace defective parts as needed.
a. Look for cracks, breaks, and abnormal
b. Look for damaged threads.
No open flames, welding, grinding, smoking, or use of heat producing devices permitted near fuel tank
and fuel lines during maintenance unless the fuel tank has been cleaned and purged of all flammable
liquids and vapors. Fuel burns easily and fumes are explosive. Keep battery disconnected. Failure to
observe these precautions could cause serious injury.
6. Filter head (1)
a. Unplug filter head (1).
b. Screw in and tighten to position noted
during removal using 0 to 1.322-inch