FUEL SHUTOFF VALVE - CONTINUED
No open flames, welding, grinding, smoking, or use of heat producing devices permitted near fuel tank
and fuel lines during maintenance unless the fuel tank has been cleaned and purged of all flammable
liquids and vapors. Fuel burns easily and fumes are explosive. Keep battery disconnected. Failure to
observe these precautions could cause serious injury.
1. Loader backhoe
Drain (page 2-250).
Do not connect fuel line or battery
cable at this time.
2. Fuel tank (1)
Fuel shutoff valve
a. Note relative position of valve (2) for
(2) and filter
proper placement during installation.
b. Using multiple tongue and groove slip-
joint pliers, unscrew and take out.
c. Cap fuel tank (1) (page 2-137).
3. Fuel shutoff
Filter element (3)
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use only
in a well ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe vapors. Do not
use near open flame or excessive heat. The flashpoint is 1000F to 138F (380 to 590C). If you become
dizzy while using cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is
made, wash your eyes with water and get medical aid immediately.
4. All parts
a. Clean in drycleaning solvent.
b. Using clean, dry rags, wipe dry.