INSTALLATION - CONTINUED -624880321

TM 5-2420-222-20-1

FUEL TANK - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

INSTALLATION - CONTINUED

WARNING

No open flames, welding, grinding, smoking, or use of heat producing devices permitted near fuel

tank and fuel lines during maintenance unless the fuel tank has been cleaned and purged of all

flammable liquids and vapors. Fuel burns easily and fumes are explosive. Keep battery

disconnected. Failure to observe these precautions could cause serious injury.

24.

Fuel tank (1)

Nut (3) and

a. Hold rod (2) tightly against fuel

and tie rod (2)

washer (4)

tank (1).

b. Screw on and tighten using 9/16-inch, 3/8-inch

drive deep socket and ratchet handle.

25.

Fuel shutoff

Fuel line (6)

a. Uncap.

valve (5)

b. Screw on and tighten using 5/8-inch open-end

wrench.

26.

Fuel tank (1)

Connector (7)

Screw in and tighten using 7/16-inch open-end

wrench.

27.

Connector (7)

Tube (8)

a. Uncap.

b. Screw on and tighten using 7116-inch and 1/2-

inch open-end wrenches.

28.

Fuel sender

Terminal (10)

a. Take off tag.

terminal (9)

b. Place in position.

29.

Terminal (10) and

Screw (11), new

Screw in and tighten using 3116-inch flat-

fuel sender

lockwasher (12),

tip screwdriver.

terminal (9)

and washer (13)

30.

Fuel tank and

Grille housing

Install (page 2-1035).

front support

Do not install hood at this time.

31.

Loader backhoe

Fuel system

Prime (2-340).

32.

Battery ground

Connect (page 2-396).

cable

33.

Air Cleaner

Install (page 2-237).

34.

Engine

Start and run at high idle

(TM 5-2420-222-10).

2-260