AIR CLEANER - CONTINUED
For more information on how to clean parts, go to General Maintenance Instructions
Compressed air used for blowing away chips, dirt, etc., must leave nozzle at less than
30 psi (207 kPa) to prevent personal injury. Be certain that nozzle is rated to provide a
maximum of 30 psi (207 kPa). Be sure to wear safety goggles or lenses when using
compressed air. Compressed air and particles moved by compressed air can cause
damage to your eyes.
Do not tap air cleaner element against hard surfaces. When cleaning air cleaner
element, use 30 psi (207 kPa) or lower, compressed air. Element can be damaged by
rough handling and high pressure compressed air.
Air cleaner filter
a. Tap against hand several times to
b. Using reciprocating air compressor,
air compressor hose, and air blow
gun, blow out dirt.
Unloader valve (2)
a. Using clean rags dampened with
and special screw (3)
solution of detergent and water,
b. Using clean water, rinse.
c. Using clean, dry rags, wipe dry.
Drycleaning solvent PD680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes
and don't breathe vapors. Do not use near open flame or excessive heat. The
flashpoint Is 1000F to 1380F (380 to 590C). If you become dizzy while using cleaning
solvent, get fresh air immediately and get medical aid. If contact with eyes is made,
wash your eyes with water and get medical aid immediately.
Air cleaner (4) and
a. Using clean rags dampened in dry-
cover with attached
cleaning solvent, wipe clean.
b. Using clean, dry rags, wipe dry.