 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2420-222-20-1
CLUTCH PEDAL LINKAGE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT'
NOTE
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-137).
Replace defective parts which cannot be repaired.
21.
All parts
Look for breaks, bends, and cracks.
22.
All threaded parts
Look for damaged threads.
REPAIR
23.
All threaded parts
If threads are damaged, using screw
except hardware
threading set, restore threads.
ASSEMBLY
24.
Rod (1)
Nut (2) and
a. Place rod (1) in machinist's vise with
yoke or clevis (3)
vise jaw caps.
b. Screw on until same number of exposed
threads are showing on rod (11) and
relative position of yoke or clevis (3)
is same as noted during disassembly.
25.
Rod (1) and
Nut (2)
a. Using 9/16-inch open-end and 0 to
yoke or clevis (3)
1.322-inch adjustable wrenches,
tighten until seated against yoke or
clevis (3).
b. Take rod (1) out of machinist's vise
with vise jaw caps.
26.
Yoke or clevis (3)
Bellcrank (4)
Place in position.
27.
Yoke or clevis (3)
Pin (5)
Slide in.
and bellcrank (4)
28.
Pin (5) and
New cotter pin (6)
a. Push in.
yoke or clevis (3)
b. Using slip-joint pliers, bend ends
back.
29.
Rod end (7)
Nut (8) and
a. Place rod end (9) in machinist's vise
yoke or clevis (9)
with vise jaw caps.
2-190
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals