 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2420-222-20-1
LUBRICATING COOLER (ENGINE OIL COOLER) - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
17. Cooler (1)
New packing (2)
Place In position.
18. Engine block (3)
Cooler (1)
Place in position.
and nipple (4)
19. Cooler (1) and
Nipple (5)
a. Screw in and tighten until snug using
nipple (4)
1 1/16-inch, 1/2-inch drive socket and
ratchet handle.
b. Using 1 1/16-inch, 112-inch drive
socket and 0 to 150 foot-pound capacity
torque wrench, tighten to 20 to 25 foot-
pounds (27 to 34 N.m) torque.
20. Cooler (1)
Two hoses (6) with
Place position.
assembled clamps (7)
21. Two hoses (6)
Two clamps (7)
Using 1/4-inch flat-tip screwdriver,
tighten.
22. Cooler (1)
Plug (8)
Screw in and tighten using 5116-inch open-
end wrench.
23. Loader backhoe
Radiator
Fill (page 2-368).
Do not start engine at this time.
24.
Engine oil filter
Install (page 2-168).
element
Do not shut down engine at this
time.
25.
Engine
Run at high idle (TM 5-2420-222-10).
26.
Engine lubricating
a. Check for oil and coolant leaks.
cooler
b. If coolant is found leaking at any con-
nection tighten clamps (7) using
1/4-inch flat-tip screwdriver.
c. If coolant leak does not stop or if oil
leak is found, shut down engine
(TM 5-2420-222-10) and replace
defective packing or component as out-
lined in this task.
2-160
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals