 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-28. EXHAUST MANIFOLD - REPLACE (Cont'd)
Installation
b.
NOTE
If exhaust manifold studs are
loose or if new exhaust manifold
studs are being used, put anti-
seize compound on threads to be
installed in cylinder head and
tighten studs to a torque of
203 lb. ft.
(1) Install six gaskets (11) on
cylinder head studs.
(2) Put anti-seize compound on
threads of exhaust manifold
studs.
(3) Place exhaust manifold (5) in
position on studs and install ten
washers (9) and ten nuts (10)
that hold exhaust manifold (5).
Use a wrench to tighten nuts (10)
to a torque of 325 lb. ft.
(4) Install 1 washer (9) and spacer (8)
in correct location.
(5) Install washer (7) and spacer (6)
in correct location.
(6) Place heat shield (4) in position ,
and install two washers (3) and
two nuts (1) that hold heat
shield (4) to exhaust manifold
(5). Tighten nuts (1) using a
wrench.
(7) Install fuel injection lines.
See TM5-241O-237-2O.
(8) Install turbocharger. See TM5-
2410-237-20.
(9) Install muffler. See TM5-2410-
237-20.
c. Place In Service
Run engine and check for proper
operation.
3-123
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals