 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-2410-237-34
CAMSHAFT AND CAMSHAFT BEARINGS - REPLACE (Cont'd)
3-23.
CAUTION
Remove the camshaft with care to
avoid damaging the bearing.
If bearing is not damaged, do not
remove.
(4) Pull the camshaft (6) out of the
cylinder block.
(5) Use a wrench to remove the
capscrews (7) from the camshaft
gear (2). Remove the gear (2)
from the camshaft (6).
(6) If necessary to remove bearings,
use bearing puller to remove
bearing (8) and four bearings
(9) from cylinder block (10 ).
b. Installation
(1) Use a suitable bearing
installation tool to Install the
front bearing (9) (the bearing
with two oil holes) in the
cylinder block with the bearing
oil holes in alignment with the
oil holes in a horizontal
position and with the bearing
joint at the top. The bearing
joint angle must be within the
15 from vertical position (X).
The installation depth or
dimension A of the front bearing
from the front face of the block
is 0.02O.02 in.
3-105
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals