 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-16.
FLYWHEEL - REPLACE/REPAIR (Cont'd)
c. Assembly
(1) Heat ring gear (6) to no more
than 600 F.
(2) Install ring gear (6) so the
chamfer on the gear teeth is
facing toward the engine when the
flywheel (2) is installed.
d. Installation
(1) Make an alignment of the dash
marks on flywheel (2) and gear
(5). Install gear (5) on
flywheel (2).
(2) Attach flywheel (2) to lifting
equipment (1) and lift flywheel
(2) into place.
(3) Make an alignment of the
dash marks on flywheel (2) and
crankshaft (7) and place flywheel
(2) against the rear of the
crankshaft (7).
(4) Use a torque wrench to install
nine capscrews (3) and nine
washers (4) to a torque of
15020 lb. ft.
(5) Remove lifting equipment (1) from
flywheel (2).
(6) Install torque divider. See
page 7-8.
e. Place In Service
Run engine and check for proper
operation.
3-72
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals