 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-13. CRANKSHAFT REAR SEAL AND WEAR SLEEVE - REPLACE (Cont'd)
(2) Clean outer diameter of
crankshaft flange (11) and
inside diameter of wear sleeve
(9) l
(3) Apply Loctite 262 on the outer
diameter of crankshaft flange
(11) and on the inside diameter
of the wear sleeve (9).
(4) Put seal (6) and wear sleeve (9)
assembly on locator (10) with
part number on seal facing out.
(5) Apply clean lubricating oil on
washer face (A) of nut (13).
Place installer (12) on locator
(10), then install nut (13).
(6) Turn nut (13) until inside
surface of installer (12) comes
in contact with the locator (10).
The rear seal and wear sleeve
will be in the correct location.
(7) Remove nut, installer (12), and
locator (10).
(8) Coat outside surface of washer
(5) with multipurpose grease,
and install washer (5) on stub
shaft.
(9) Install washer (3) on shaft (2).
(10) Put gear (4) on shaft (2); then
install gear and shaft. Use a
wrench to install capscrews (1)
and tighten to a torque of
7510 lb. ft.
(11) Install flywheel. See page 3-71.
co Place In Service
Run engine and check for proper
operation.
3-64
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals