|
|
TM5-241O-237-34
3-11. CRANKSHAFT BEARINGS - REPLACE (Cont'd)
(2) Remove two thrust plates (6)
from No. 7 main bearing.
CAUTION
If the crankshaft is turned in
the wrong direction, the tab
on the upper half of the
bearing will be pushed between
the crankshaft and bearing
area in the block. This could
cause damage to the block and
the crankshaft.
(3) Slowly turn crankshaft in the
correct direction until the
bearing journal oil holes are
accessible to insert bearing
removal tool. Insert bearing
removal tool through the oil hole
in the bearing journal. Slowly
turn the crankshaft (7) until
upper bearing half (8) is out of
the cylinder block.
b. Cleaning
CAUTION
Never use any type of rough
material or tools such as
sandpaper, emery or crocus
cloth, files, or glassbead
cleaning equipment to clean
bearings.
Clean removed parts with an
approved cleaning solvent and
dry thoroughly with lint-free
wiping rags (See page 2-29).
If bearings, bearing caps, and
thrust plates are not to be
installed within one hour after
cleaning, apply a thin film of
lubricating oil over them.
3-52
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |