 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-10. CRANKSHAFT ASSEMBLY - REPAIR/REPLACE (Cont'd)
NOTE
Install bearing caps (9) with the
part number toward the front of
the engine. Be sure that the mark
(number) on the bearing cap
corresponds with the mark in the
cylinder block.
(4) Place main bearing caps (9) in
position. Put clean lubricating
oil on the threads of capscrews
(7) and on the face of washers
(8). Use a wrench to install
capscrews and washers. Tighten
capscrews to a torque of 27 to
33 lb. ft. Do not remove floor
jack from crankshaft at this
time.
CAUTION
Do not use an impact wrench to
tighten main bearing cap
capscrews the additional 90
degrees.
(5) Put a mark on each bearing cap
(9) and capscrew (7). Tighten
capscrews 90 degrees more.
(6) Use a wrench to remove all of
the capscrews (7) and washers
(8), then remove bearing caps
(9).
(7) Put clean lubricating oil on
thrust plates (12). Install
thrust plates for the No. 7
bearing, with the words "BLOCK
SIDE" toward the cylinder block
(11). The thrust plates have tabs
which must be inserted into the
machined area in the block. The
tabs prevent incorrect
installation.
(8) Perform STEPS 4 and 5 above.
3-49
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals