 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-10. CRANKSHAFT ASSEMBLY - REPAIR/REPLACE (Cont'd)
d. Inspection
(1) Visually inspect crankshaft for:
(a) Large, deep cracks or broken
material throughout the
crankshaft, especially in the
fillet and journal areas.
(b) A high concentration of
depressions or pitting.
(c) Burning or scoring in the
journal areas.
(d) Cracks in the oil holes.
(e) Damage
to the tapered end of
shaft,
keyway, and gear that
cannot
be corrected by simple
filing
or polishing.
(f) If any of the above conditions
(a through e) exist, replace
the crankshaft.
(2) See page 2-32 for general
Inspection Instructions.
e. Assembly
(1) Apply lubricating oil on the rear
seal lip (18).
(2) Clean the crankshaft flange and
inside diameter of the wear
sleeve (18) with quick cure
primer.
(3) Apply Loctite 262 on the
crankshaft flange and on the
inside diameter of the wear
sleeve (18).
CAUTION
Do not separate rear seal and
wear sleeve. If this assembly
is separated, it will not
function.
3-46
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals