 |
|||
|
|
|||
|
Page Title:
Table 2-1. Direct Support and General Support Troubleshooting Table - continued |
|
||
| ||||||||||
|
|
 TM5-241O-237-34
Table 2-1.
Direct Support and General Support Troubleshooting Table (Cont'd)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
37. TORQUE DIVIDER OVERHEATS
Step 1.
Replace relief valve for torque divider input (page 7-79).
This valve is located in the sequence relief valve.
Step 2.
Test outlet pressure from torque divider (page 7-98).
If necessary, repair or replace relief valve for torque divider output
(page 7-86).
Step 3.
The problem could be that there is excessive oil in the engine flywheel
housing and torque divider cover.
a.
Clean torque divider screen assembly (TM5-2410-237-20).
b.
Repair torque divider (page 7-8).
c.
Repair or replace torque divider scavenge pump (page 7-92).
END OF TESTING!
38. LOSS OF TORQUE DIVIDER OIL
Step 1.
Check for oil around torque divider scavenge pump cover gasket.
Replace cover gasket, if necessary (page 7-92).
Step 2.
Check for oil around flywheel housing-to-torque divider cover area.
Replace flywheel housing-to-torque divider housing cover gasket, if
necessary (page 7-8).
Step 3.
Check for oil around torque divider output shaft. Replace output shaft
seal, if necessary, or repair torque divider (page 7-8).
Step 4.
Check for oil around flywheel housing-to-engine block area.
If necessary, replace flywheel housing-to-engine block gasket (page 3-72).
END OF TESTING!
2-20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals