 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
ASSEMBLY - CONTINUED
i.
Apply RTV compound on mating surfaces on retainer (47) and drum (30).
j.
Install retainer (47) on drum (30) with six bolts (46). Tighten bolts to 85 lb-ft (115 Nm).
k.
Install new O-ring (53) on drum (30).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Drum weighs 251 lb (114 kg).
l.
Fasten lifting equipment to drum (30) and position it in case (5).
CAUTION
Tighten capscrews (31) evenly to avoid damaging O-ring (53).
m.
Install three capscrews (31) and washers (32) to hold drum support flange (33) to drum (30).
n.
Remove wire and lifting link from drum support flange (33). Position floor jack and wood block under right side of
drum (30). Remove lifting equipment from drum.
0245 19-37
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals