|
|
TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
DISASSEMBLY - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Drive gear weighs 126 lb (57 kg).
v.
Tighten forcing screws evenly to push drive gear (29) off spline and onto wood block. Remove forcing screws.
w.
Roll drive gear (29) forward in case (5).
x.
Fasten lifting equipment to drive gear (29). Lift drive gear until wood block can be removed. Remove wood block,
then remove drive gear from case (5).
NOTE
Drum weighs 251 lb (114 kg).
y.
Fasten lifting equipment to drum (30).
z.
Remove remaining three capscrews (31) and washers (32) that were left in drum (30).
aa.
If used, remove floor jack and wood block from underneath drum (30).
NOTE
Drum support flange weighs 81 lb (37 kg).
ab. Install two lifting links of correct size in drum support flange (33).
33
30
34
5
29
421-0212-1
Change 1
0245 19-8
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |