 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRANSMISSION PRESSURE CONTROL VALVE REPAIR - CONTINUED
0245 17
ASSEMBLY
NOTE
Lightly coat all transmission pressure control valve components with clean oil before assembly.
1.
Install two plugs (25) on valve body (3).
2.
Install two new O-rings (24) on valve body (3).
NOTE
Spacers and shims are added or removed, as needed, to adjust relief valve setting.
Each 0.035 in. (0.90 mm) spacer (washer, flat, P/N 5M7915) will change relief valve setting by 10.9 psi
(75 kPa).
Each 0.010 in. (0.25 mm) shim (P/N 11634204-2) will change relief valve setting by 2.9 psi (20 kPa).
Unless power train hydraulic system test results (WP 0122 00) have indicated the need to add or
remove spacers and shims, the same number should be installed as were removed.
3.
Install new shim (21), new spacers (22) and new shim
24
(23) inside piston (20). Install piston in valve body (3).
25
20
21
3
22
23
421-0176
4.
Install new spring (19), valve (18), new slug (17) and
11
13
stop (16) in valve body (3).
3
5.
Install valve (15) in valve body (3).
6.
Install new retainer (14) in valve body (3), with large
inside diameter toward spring (10).
19
12
18
NOTE
16
17
Pins must not extend into spring bore of
retainer.
15
7.
Install two new pins (13) to secure retainer (14).
14
8.
Install cover (12) on valve body (3) with four bolts
421-0175
(11). Tighten bolts to 35 lb-ft (47 Nm).
10
9.
Install new spring (10) in valve body (3).
0245 17-5
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals