ASSEMBLY - CONTINUED - TM-5-2410-237-231462

TM 5-2410-237-23

TRANSMISSION ASSEMBLY REPAIR - CONTINUED

0245 15

ASSEMBLY - CONTINUED

14.

Lower temperature of bearing cup (161) and install it

in bearing cage (155).

161

(HIDDEN)

155

421-0260

15.

Lower temperature of race and roller assembly (160)

and install race and roller assembly in bearing cage

(155).

160

(HIDDEN)

155

421-0261

16.

Install new retaining ring (158) to retain race and roller assembly (160) in place.

17.

Install original shims (157) and bearing cage (155) on transfer gear case (19).

18.

Increase or decrease the number of shims in order to achieve end play measurement of 0.0046 0.0026 in. (0.117

0.066 mm) at point A.

19.

Install six capscrews (153) and washers (154) on bearing cage (155). Tighten capscrews to 35 3 lb-ft (48 4 Nm).

20.

Set transfer gear case (19) face down.

21.

Install dial indicator as shown. Ensure that indicator arm contacts gear (169) in transfer gear case. Move gear up and

down while checking end play. End play must be 0.0046 0.0026 in. (0.117 0.066 mm).

22.

Remove six capscrews (153), six washers (154), bearing cage (155) and shims (157) from transfer gear case (19).

23.

Lower temperature of bearing (164) and install it in bearing cage (163).

NOTE

Apply thin coat of clean oil to rings.

24.

Install two new rings (165) on bearing cage (163).

25.

Install bearing cage (163) in transfer gear case (19). Ensure that groove in bearing is aligned.

26.

Install new retaining ring (162) on retain bearing (164) in bearing cage (163).

27.

Install output shaft (159) in transfer gear case (19) and retain in position with another new retaining ring (158).

28.

Install shims (157) and bearing cage (155) on transfer gear case (19).

29.

Install six capscrews (153) and washers (154) to secure bearing cage (155) to transfer gear case (19). Tighten capscrews

to 35 3 lb-ft (48 4 Nm).

Change 1

0245 15-26