|
|
TM 5-2410-237-23
FUEL INJECTION PUMP MAINTENANCE - CONTINUED
0245 09
INSTALLATION - CONTINUED
7.
Apply clean lubricating oil to new O-ring (8) and install in fuel injection pump housing (4).
8.
Install new bushing (7) by hand-turning until bushing is even with top of fuel injection pump housing (4). If bushing
cannot be installed by hand, remove bushing.
9.
Remove fuel injection pump (9). Realign and reinstall bushing (7).
10.
Use wrench to tighten bushing (7) to 120 10 lb-ft (163 14 Nm).
NOTE
Minimum travel for rack is 0.618 in. (15.70 mm). A smaller measurement indicates improper fuel injection
pump (4) installation.
11.
Use rack position tool to measure total travel of rack.
10
12.
Repeat steps 1 through 11 to install remaining fuel
injection pumps (9).
9
7
13.
Install cover (2) and new gasket (3) on fuel injection
pump housing (4).
8
14.
Install four bolts (1) and tighten to 27-33 lb-ft (37-45
Nm).
5
6
(HIDDEN)
421-0146
3
1
4
2
15.
Install fuel injector lines (WP 0044 00).
END OF WORK PACKAGE
0245 09-7
Change 1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |