 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
0245 07
INSTALLATION - CONTINUED
3.
Install four capscrews (12) to secure camshaft gear (13). Tighten to 35-45 lb-ft (47-61 Nm).
NOTE
Replace discarded lock (10) with two new washers (15).
4.
Place new shaft (11) into position and install bolts (8), new washers (15), and new nut (9).
5.
Install new bearing (7) into gear (6) using a press so
3
bearing is 0.12 in (3.0 mm) below the outside surface.
11
Bearing inside diameter after installation must be
2
9
1.3781 0.0019 in (35.004 0.048 mm).
7
1
6.
Install gear (6) on shaft (11) and install plate (5) and
two capscrews (4) that secure gear (6). Tighten cap-
screws.
7.
Install timing pin in fuel injection pump (WP 0055
15
8
8.
With timing pin installed in fuel injection pump and
5
4
"C" on the camshaft gear (13) and the crankshaft gear
6
(14) aligned, install fuel pump drive gear (3).
9.
Install capscrew (1) and new washer (2) to secure gear
12
(3) to engine. Apply a clockwise torque of 50 lb-ft (68
Nm) on the fuel pump drive gear (3). Tighten cap-
screw to 200 20 lb-ft (271 27 Nm).
13
10.
Remove timing pin from fuel injection pump (WP
421-0144
11.
Install front housing cover (WP 0245 05).
END OF WORK PACKAGE
0245 07-5
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals