 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
0245 04
INSTALLATION - CONTINUED
NOTE
Ensure that the tabs on the back of bearings are in the tab grooves of the connecting rod and cap.
8.
Install new connecting rod bearing halves (3) and cap (2) in position on the connecting rod. Install the nuts (1) onto bolts
(16) and tighten to 27-33 lb-ft (37-45 Nm). Mark each nut and the end of each bolt. Tighten nuts an additional 90
degrees.
CAUTION
When connecting rod caps are installed, ensure the number on side of cap is next to the same number on
side of corresponding connecting rod.
9.
Follow steps 1 through 8 for the installation of the other pistons.
10.
Install engine oil pump (WP 0035 00).
11.
Install oil pan plate (WP 0034 00).
12.
Install cylinder head assembly and spacer plate (WP 0025 00).
END OF WORK PACKAGE
0245 04-11
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals