|
|
TM 5-2410-237-23
AIR CONDITIONING INSTALLATION INSTRUCTIONS - CONTINUED
0229 03
A/C COMPRESSOR INSTALLATION - CONTINUED
NOTE
Apply a thin coat of oil to seal prior to installation.
7.
Using bushing driver set, transfer pump handle, socket
head capscrew, and socket wrench, install lip-type seal
(103) in cover (104) to a depth of 0.59 0.31 in. (1.5
103
0.8 mm) below outside surface. Make sure lip of seal
is toward inside of cover.
104
421-0352
8.
Fit new gear (105) into front gear train, with interior shoulder inserted into existing bearing (106).
9.
Install new bearing (107) on gear (105).
10.
Install new gasket (108) and cover (104) on timing gear plate, using bolts and washers removed in step 4.
11.
Install block (109) on cover (104), using two new longer bolts (110 and 111).
12.
Secure fumes disposal tube with clip (98) from step 3.
13.
Use washer (112) as a spacer on bottom hole of block (109).
14.
Install key (113) in shaft (114).
15.
Align splines on shaft (114) with splines in water pump gear (101).
16.
Install shaft (114) in water pump gear (101).
17.
Align key in shaft (114) with groove in pulley (115) and install pulley on shaft.
18.
Install new O-ring seal (116), new washer (117), and new bolt (118) that hold pulley (115) on new shaft (114). Tighten
bolt to 71 5 lb-ft (96 7 Nm).
106 (HIDDEN)
106
105
107
103
114
108
115
104
116
113
117
118
109
98
110
112
111
421-0353
Change 1
0229 03-18
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |