|
|
TM 5-2410-237-23
BLADE TILT CYLINDER HYDRAULIC LINES AND FITTINGS - CONTINUED
0214 00
INSTALLATION - CONTINUED
NOTE
Lightly coat new O-rings with clean oil before installation.
1.
Install new O-ring (6), hydraulic line (5), two split flanges or regular flange (4), four capscrews (2), washers (3) and nuts
(1).
2.
Install new O-ring (9) on connector (7) and install connector on end of hydraulic line (8).
NOTE
Mounting hardware for clamps and retaining straps may vary depending on their type and location.
3.
Install clamp (12) on hydraulic line or lines with washer (11) and capscrew (10).
4.
Install clamp (17) and retaining strap (16) to hydraulic lines with capscrew (14), washer (15) and nut (13).
5.
Check oil level in hydraulic tank. Refill tank and bleed air from system, as required (WP 0225 00).
6.
Cycle cylinders and check for proper operation and leaks. Stop engine and reposition fittings if lines pull tight.
7.
Ensure that oil level is still visible in sight gage on hydraulic tank. Add oil as needed (WP 0225 00).
8.
Install radiator grilles (WP 0068 00).
END OF WORK PACKAGE
0214 00-3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |