 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
RIPPER HYDRAULIC LINES AND FITTINGS REPLACEMENT - CONTINUED
0212 00
REMOVAL - CONTINUED
NOTE
Tag hydraulic lines to ensure correct installation.
Use a suitable container to catch any hydraulic oil that may drain from system. Dispose of oil IAW local
policy and ordinances. Ensure all spills are cleaned up.
1.
For hydraulic lines with split or regular flange fittings, remove four capscrews (1), washers (2), two split flanges or reg-
ular flange (3), line (4) and O-ring (5). Discard O-ring.
2.
For hydraulic lines with connector fittings, disconnect line (6) from fitting (7). Remove O-ring (8) from fitting and dis-
card O-ring. Remove fitting.
NOTE
Mounting hardware for clamps may vary depending on type and location of clamp.
3.
For lines held in position with clamps, remove capscrew (9), washer (10) and clamp (11) from lines.
HYDRAULIC TANK
7,8
BLADE CONTROL
VALVE
6
PILOT VALVES
4
ENGINE
1,2
3
HYDRAULIC
PUMP
5
PRESSURE
CONTROL
VALVE
11
RIPPER
9,10
CONTROL
VALVE
387-683
0212 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals