|
|
TM 5-2410-237-23
BLADE TILT CYLINDER REPAIR - CONTINUED
0210 00
ASSEMBLY - CONTINUED
8.
Place head (1) on cylinder housing (2) and install two bolts (3) to hold head in place.
CAUTION
Piston rod must be supported and kept level at all times to avoid damaging seals in head.
9.
Place seal guide on piston end of piston rod (5). Push piston rod into head (1) as far as possible.
10.
Remove two bolts (3) and separate head (1) and piston rod (5) as a unit from cylinder housing (2).
CAUTION
Protect piston rod and use care when placing in vise.
NOTE
Lightly coat threads on piston rod and piston with clean oil before assembly.
Ensure seal guide is installed on end of piston rod before assembly.
11.
Install piston (7) on piston rod (5).
12.
Install new self-locking nut (8) on piston rod (5) and tighten to 1600 lb-ft (2169 Nm).
NOTE
To ensure proper alignment and fit, ensure scribe marks on head and cylinder housing are in alignment.
13.
Install head (1) and piston rod (5) into cylinder housing (2).
NOTE
Tighten bolts evenly to draw head all the way on cylinder housing.
Piston rod must be fully extended when bolts are tightened for correct alignment of cylinder housing
and head.
3
4
1
7
8
2
5
387-654
0210 00-6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |