 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
RIPPER CONTROL LEVER AND LINKAGE REPLACEMENT - CONTINUED
0208 00
REMOVAL
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,237
kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground
and shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic
tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic
fluid under pressure can penetrate the skin, causing serious injury or death.
9,10
1.
Remove knob (1) from blade control lever (2).
11,12
2.
Remove knob (3) from ripper control lever (4).
13
3.
Remove two capscrews (5), washers (6) and armrest
3
(7) from side of control console (8).
2
4.
Remove eight capscrews (9), washers (10), capscrew
4
(11) and washer (12) from cover (13).
5.
Remove cover (13) from control console (8).
1
8
7
5,6
387-652
6.
Remove dome (14) and spring (15) from ripper control lever (4).
7.
Remove two capscrews (16) and washers (17) from boot flange (18) at bottom of control linkage.
8.
Slide boot (19) and boot flange (18) partially up lower rod (20).
9.
Remove cotter pin (21) and pin (22) to disconnect lower rod (20) from ripper pilot valve (23). Discard cotter pin.
10.
Remove two capscrews (24) and washers (25) from bracket (26) assembly and remove bracket assembly from control
console (8).
0208 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals