 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
PERSONNEL HEATER MAINTENANCE - CONTINUED
0192 00
ASSEMBLY
1.
Install screen (16) into heater cover (17).
2.
Place heater core (15) into heater cover (17).
3.
Place fan motors (14) on support panel (13) and secure with four washers (20) and nuts (19). Install new tiedown strap
on motor wires.
4.
Slide fan blades (18) onto fan motor (14) shafts.
5.
Place support panel (13) in position in heater cover (17). Install two capscrews (12) at top rear of cover to hold panel in
position.
12
13
15
14
17
17
16
387-492
387-493
INSTALLATION
1.
Position heater (5) on mounting brackets (11) on floor
1
and install ground wire (10) in lower rear corner of
heater with capscrew (8) and washer (9).
2.
Install remaining three capscrews (8) and washers (9)
to heater (5) and mounting brackets (11).
3.
Install two hoses (7) and tighten hose clamps (6).
4.
Connect two fan motor wires (4). Push insulation
panel (3) back into position and fasten with button (2).
5.
Open two water shut-off petcocks (1) on heater hoses
in engine compartment.
6.
Place battery disconnect switch in ON position (TM 5-
387-297
2410-237-10).
7.
Start engine and check level of coolant in radiator. Add coolant as needed (WP 0065 00).
8.
Check personnel heater for proper operation and leaks.
9.
Shut down engine (TM 5-2410-237-23).
END OF WORK PACKAGE
0192 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals