SEAT AND SEAT BASE ASSEMBLY INSTALLATION (Cont)

TM 5-2410-237-23

SEAT, SEAT BASE ASSEMBLY AND SEAT BELT REPLACEMENT - CONTINUED

0172 00

SEAT AND SEAT BASE ASSEMBLY INSTALLATION- CONTINUED

21.

Install battery cables (WP 0101 00).

22.

Install floor plates (WP 0171 00).

23.

Install battery disconnect switch (WP 0090 00).

24.

Install winterized cab (if equipped) (WP 0168 00).

25.

26.

Perform Adjustment.

SEAT ADJUSTMENT

WARNING

Seat is properly adjusted when operator can fully depress brake pedals. All controls must be at proper

operating distance from operator. An unsafe condition exists when controls cannot be reached. Failure to

make proper adjustments may result in serious personal injury or death.

Loosen two capscrews (56) on each side of seat vertical adjuster (2) three full turns each.

With assistance, slide seat (3) back and then up

or down as needed. Slide seat forward again after

reaching desired height.

Tighten two capscrews (56) on each side of vertical

adjuster (2).

387-459

0172 00-7