SEAT AND SEAT BASE ASSEMBLY INSTALLATION (Cont)

TM 5-2410-237-23

SEAT, SEAT BASE ASSEMBLY AND SEAT BELT REPLACEMENT - CONTINUED

0172 00

SEAT AND SEAT BASE ASSEMBLY INSTALLATION - CONTINUED

13.

Position plate (19) and install five capscrews (17) and washers (18).

14.

Position cover (16) and install eight capscrews (14) and washers (15).

15.

Install two capscrews (12) and washers (13).

16.

Position armrest assembly (11) and install two capscrews (9) and washers (10).

NOTE

Carefully guide blade control lever and winch/ripper control lever through dust covers in cover (16).

17.

Install transmission selector lever handle (6), blade control lever knob (7) and winch/ripper control lever knobs (8).

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to

personnel.

NOTE

Seat with vertical adjuster weighs 70 lb (32 kg).

18.

Attach nylon sling and suitable lifting device to back

of seat (3) and position seat with vertical adjuster (2)

in seat base assembly (5).

19.

Tilt seat (3) forward then slide seat forward and place

hinge pins (4) into hooks in seat base assembly (5).

20.

Push back of seat (3) down until locks snap into

position.

14,15

17,18

12,13

387-407

0172 00-6