 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRACK ROLLER FRAME ASSEMBLY REPLACEMENT - CONTINUED
0135 00
ALIGNMENT - CONTINUED
10
A
24 22
23
21
20
18
19
B
387-692
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
4.
Raise machine IAW (WP 0243 00) until both tracks are off ground.
5.
Release tension from tracks (WP 0143 00).
NOTE
Refer to WP 0141 00 for assistance in performing steps 6-9.
6.
Remove holder assembly (19).
7.
Remove cap (20), lock (21), nut (22), retainer assembly (23) and shims (24).
NOTE
Thickness of one shim is 0.036 in. (0.91 mm). Use the least amount of shims and do NOT use more than
seven shims on either side of machine.
The following steps must be completed on each side of machine.
8.
Change alignment of rear track carrier roller (10) in relation to final drive sprocket (18) by installing or removing
shim(s) (24) from final drive support.
a.
Install shim(s) (24) between retainer assembly (23) and holder (19) of final drive to move track roller frame out to
make distance A more.
b. Remove shim(s) (24) between retainer assembly (23) and holder (19) of final drive to move track roller frame in to
make distance A less.
9.
Install retainer assembly (23), nut (22), lock (21), and cap (20).
0135 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals