|
|
TM 5-2410-237-23
TRACK ROLLER FRAME ASSEMBLY REPLACEMENT - CONTINUED
0135 00
REMOVAL - CONTINUED
13.
Lower track roller frame (1) onto track.
14.
Remove track roller frame (1) from track.
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting device. Failure to follow this warning may result in death
or injury to personnel.
Ratchet puller must be attached to track roller frame in a manner to evenly distribute weight of frame.
Failure to do so may cause frame to tip, causing personal injury or death.
NOTE
Weight of an assembled track roller frame is 3,900 lb (1,771 kg).
1.
Attach lifting device to rear of track roller frame (1).
18
2.
Place track roller frame (1) in position on track.
3.
Lift rear of track roller frame (1) in position on final
drive sprocket (18) outer hub.
1
387-688
WARNING
Ratchet puller must be attached to track roller frame in a manner to evenly distribute weight of frame.
Failure to do so may cause frame to tip, causing personal injury or death.
4.
Attach lifting device to rear track carrier roller (10) and ratchet puller to lifting device and to recoil spring (11).
5.
Adjust ratchet puller so rear track carrier roller (10), rear support assembly (3) and recoil spring (11) are level and bal-
anced.
6.
Install cap (14) to track roller frame (1) with four new lockwashers (13) and capscrews (12). Tighten capscrews to 375
lb-ft (508 Nm).
7.
Install cap (17) to track roller frame (1) with four new lockwashers (16) and capscrews (15). Tighten capscrews to 375
lb-ft (508 Nm).
0135 00-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |