 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
BEVEL GEAR AND SHAFT REPLACEMENT - CONTINUED
0127 00
INSTALLATION - CONTINUED
NOTE
Thickness of full shim pack is 0.119-0.125 in. (3.02-3.18 mm).
a.
Install bearing cage (15) at steering clutch end of shaft with full package of shims (22) and eight capscrews (20).
Do NOT install washers. Tighten capscrews evenly.
b.
Install other bearing cage (14) at bevel gear end of shaft with eight capscrews (20) and washers (21). Do NOT
install shims at this time.
CAUTION
c.
Tighten capscrews (20) evenly while turning bevel gear shaft (19) with torque wrench, until torque reading is 70-
85 lb-in. (7.9-9.6 Nm)
d.
With feeler gage, measure gap between flange of bearing cage (14) and face of bevel gear case at each capscrew
(20). Gap must be the same around entire flange.
e.
Remove bearing cage (14) and install shims (22) on cage equal to feeler gage measurement from previous step.
14
22
15
20
20
21
24
19
24
387-451
0127 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals