|
|
TM 5-2410-237-23
0125 00
REMOVAL - CONTINUED
27.
Install two 1/2 in. -13NC forcing screws in bearing cage (27) at tapped holes (B). Tighten forcing screws evenly and
remove bearing cage from steering clutch case (6). Remove forcing screws from bearing cage.
NOTE
Dowel is located behind flange of bearing cage.
28.
Use a 1/4 in. -20NC capscrew to remove dowel (28) from bearing cage (27). Remove capscrew from dowels.
29.
Pull race and roller assembly (29) from bearing cage (27).
27
26
28
25
B
B
6
29
387-290
30.
If necessary, pull bearing race (30) from pinion shaft (31).
31
30
387-291
CLEANING
1.
Wipe clean and dry all bearing mounting surfaces in openings and on shafts.
2.
Wipe all gears clean.
3.
Clean all gasket sealing surfaces before installation of new gasket compound.
0125 00-7
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |