 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRANSMISSION OIL COOLER REPLACEMENT - CONTINUED
0109 00
WARNING
INSTALLATION - CONTINUED
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Oil cooler assembly weighs 72 lb (33 kg).
5.
Use a nylon sling and a suitable lifting device to lower oil cooler (4) into position.
6.
Install two capscrews (18) and washers (19) to secure bracket (20) to cylinder block.
3
11
10
17
10
15
4
14
13
4
20
5
6
10
19
14
13
12
10
9
387-375
8
387-374
17
18
7
16
7.
Remove nylon sling and lifting device from oil cooler (4).
CAUTION
Wipe clean all lines and fittings as connections are made to prevent contamination from entering transmis-
sion.
NOTE
Lightly coat new O-rings with clean oil before installation.
8.
Install two new O-rings (17) and tubes (15 and 16) to oil cooler (4) with four new lockwashers (14) and capscrews (13).
9.
Slide hoses (11 and 12) into position on head (3).
10.
Tighten four clamps (10).
11.
Install drain plug (7) and washer (8) to access cover (9).
12.
Install drain plug (5) and washer (6) to oil cooler (4).
0109 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals