|
|
TM 5-2410-237-23
GOVERNOR SHAFT SEAL REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
Tool kit, general mechanic's (Item 122, WP 0250
Seal (7)
Equipment Condition
Materials/Parts
Engine OFF and cool (TM 5-2410-237-10)
Oil, lubricating (Item 24, WP 0249 00)
REMOVAL
1.
Mark location of lever (1) on end of throttle shaft (2) of fuel injection pump governor (3).
2.
Remove nut (4), two washers (5) and capscrew (6) from lever (1).
NOTE
Throttle linkage may remain attached to top of lever (1).
3.
Remove lever (1) from end of throttle shaft (2) and
7
3
position aside.
387-756
8
6
4,5
2
1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |