 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
GOVERNOR AND FUEL INJECTION PUMP HOUSING REPLACEMENT - CONTINUED
0055 00
INSTALLATION - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Governor and fuel injection pump housing weighs 56 lb (25 kg).
3.
Fasten a nylon sling and suitable lifting device to governor and fuel injection pump housing (10) and place in position
on engine.
4.
Install three nuts (11) on governor and fuel injection pump housing (10) to secure to engine.
5.
Install pump drive gear (9) on taper of fuel injection pump camshaft (8).
6.
Install washer (6) and snap ring (7) on fuel injection pump camshaft (8).
7.
Install torque wrench adapter on pump drive gear (9). Use two 3/8 in.-24NF bolts, 1 in. (25.4 mm) long, to secure
adapter to puller holes in gear. Install capscrew (5). Hold torque of 45-50 lb-ft (61-68 Nm) on adapter in a rotation to the
right, and tighten capscrew to 200 +/- 20 lb-ft (270 +/- 30 Nm).
12
9
7
1,2
8 (HIDDEN)
10
3
4
387-749
11
5
6
387-751
0055 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals