 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
CRANKSHAFT REAR SEAL AND WEAR SLEEVE REPLACEMENT - CONTINUED
0027 00
INSTALLATION - CONTINUED
3.
Install seal locator (6) to end of crankshaft (5) with three bolts.
4.
Place new seal (1) and wear sleeve (4) assembly on locator (6) with part number on seal facing out.
5.
Apply clean oil on washer face of nut (7). Place installer (8) on locator (6), then install nut.
6.
Turn nut (7) until inside surface of installer (8) comes in contact with locator (6). Rear seal and wear sleeve will be in the
correct location.
7.
Remove nut (7), installer (8), three bolts and locator (6).
8.
Install rear accessory drive idler gear (WP 0037 00).
9.
Install flywheel (WP 0030 00).
10.
Run engine and check for proper operation and leaks (TM 5-2410-237-10).
END OF WORK PACKAGE
0027 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals