|
|
TM 5-2410-237-23
CRANKSHAFT REAR SEAL AND WEAR SLEEVE REPLACEMENT - CONTINUED
0027 00
REMOVAL - CONTINUED
3.
Insert distorter ring (2) in rear seal bore.
4.
Insert wear sleeve distorter (3) between distorter ring (2) and wear sleeve (4).
5.
Turn distorter (3) until it makes a crease in wear sleeve (4). Make additional creases in wear sleeve, every 90 degrees,
then every 45 degrees, until wear sleeve is loose.
6.
Remove wear sleeve distorter (3) and wear sleeve (4). Discard wear sleeve.
1
3
4
2
387-230
387-229
INSTALLATION
CAUTION
Do not separate rear seal and wear sleeve assembly.
1.
Clean outer diameter of crankshaft flange (5) and inside diameter of new wear sleeve (4).
2.
Apply sealing compound on outer diameter of crankshaft flange (5) and on inside diameter of wear sleeve (4).
5
1
5
6
6
8
7
4
BOLTS
387-232
0027 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |