 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 b. Removal and Installation. Refer to TM 5-
(d) With the connecting link disconnected,
2410-233-20 and remove or install the hydraulic
position
lever
(9)
in
NEUTRAL
detent.
pump.
(e) P o s i t i o n l e v e r ( 1 ) i n c e n t e r o f n e u t r a l
c. Disassembly and Assembly.
slot.
(1) Refer to figure 6-31 and disassemble the
(f) Adjust length of short rod to enter ends
pump.
of levers (6) and (9).
(2) When the pump is disassembled, inspect
(g) Place
selector
lever
(1)
in
NEUTRAL
o i l seal (20) i n
cover
assembly
(18).
p o s i t i o n of forward slot.
(3) Bolts (5) have flat washers which must be
(h) Adjust length of longer rod to enter the
i n place when the pump is assembled.
ends of levers (1) and (8).
(4) Assemble the pump in the reverse order of
NOTE:
disassembly.
(5) Fill the pump with clean oil and rotate the
d r i v e gear prior to installation. This will place a
film of oil on the pump gears and body, and aid in
6-5.
hydraulic
Pump
priming the pump.
a. G e n e r a l . T h e s t e e r i n g c l u t c h a n d t r a n s -
packings
and
the
preformed
(6) Inspect
mission hydraulic pump is a single section gear
replace if necessary before connecting the hydraulic
type pump which is bolted to the front of the rear
lines.
power takeoff housing.
Key to figure 6-31.
1
Bolt
2 Washer
3 Screw
4 Washer
5
Bolt
6 Washer, flat
7 Manifold, flat
8 Packing
9 Bearing
10 Body
11 Packing
12 Gear
13 Gear
14 Bearing
15 Bearing
16 Bolt
17 Washer
18 Cover assembly
19 Packing
20 Seal
21 Plug
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals