Inspection and Repair. - TM-5-2410-233-340101

4-6. Tilt Control Valve

a. Removal.

(1) Drain the hydraulic tank. Refer to TM 5-

compressed air.

2410-233-20.

d. Inspection and Repair.

(2) Remove the blade tilt control valve

(1) The valve (7) must slide freely in its bore in

mounting plate and manifold from the tank (para

valve body (20). Inspect chamfered seating surface

of valve (7) and mating seat in body for nicks or

(3) Remove bolts (1, fig. 4-16) securing

manifold (3) to plate (2).

burrs.

(2) Inspect seals (18) and (19) and replace if

NOTE

deteriorated.

Bolt (5) must be in plate installing manifold (3)

on plate (2).

(3) Inspect body (20) for smooth bores.

Replace if bore surfaces are nicked, scored, or

(4) Remove bolt (4) and remove tilt control

pitted.

valve (7) from plate (2). At installation, be sure

e . Reassembly and Installation. R e v e r s e

bolt holes in valve body are aligned with bolt holes

disassembly and removal procedure and assemble

in plate to receive bolts (1).

and install the ripper control valve in the hydraulic

(5) Remove bolts (9) and baffle tube (10).

tank.