 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
RIPPER ASSEMBLY MAINTENANCE - CONTINUED
0173 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Beam weighs 2,000 lb (908 kg).
Frame assembly weighs 990 lb (449 kg).
Connecting link weighs 227 lb (126 kg).
Ripper lift cylinder weighs 206 lb (93 kg).
Clean all parts, pins and bores thoroughly before installation.
It may be necessary to temporarily install lower pins to achieve proper alignment of frame
assembly and mounting brackets.
Lubricate pin assemblies with clean grease before installation.
1.
Attach a suitable lifting device to frame assembly (2) and align frame assembly to mounting brackets (11) on back of
tractor. Place blocks underneath frame assembly. Remove lifting equipment.
NOTE
Install lift cylinder with cylinder eye toward machine and port tubing up.
2.
Use a nylon sling and a suitable lifting device to position and align lift cylinder (6) in frame assembly (2).
3.
Install pin assembly (23) through inside of frame assembly (2) and mounting bracket (11), to secure lower portion of lift
cylinder (6). Place a block underneath cylinder and lower lift cylinder on block.
4.
If removed, install grease fitting (24) in pin assembly (23).
5.
Install two spacers (22), plate (21), two new lockwashers (20) and bolts (19) to each side of frame assembly (2).
6.
Repeat steps 2 through 5 for other lift cylinder (6).
0173 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals