 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
RIPPER ASSEMBLY MAINTENANCE - CONTINUED
0173 00
REMOVAL - CONTINUED
12.
Install a draft pin through front pin holes (12) of beam (1).
13.
Attach a suitable lifting device on bar between two lift points (13) on beam (1).
14.
Remove two bolts (14) and plate (15) from pin assembly (16) securing frame assembly (2) to beam (1).
15.
Repeat step 14 to remove pin assembly (16) on other side of frame assembly (2) and beam (1).
16.
Remove grease fitting (17) from each end of each pin assembly (16), if required.
NOTE
Put slack in slings before attaching chains.
17.
Install a bar through bore (18) and, with a suitable three-point lifting device, remove beam (1) from frame assembly (2).
18.
Attach a suitable lifting device to frame assembly (2) and lift frame so it is level with tractor. Place blocks underneath
frame assembly.
NOTE
Before removal, tag lift cylinders as left and right to ensure correct installation.
19.
With a nylon sling and a suitable lifting device attached, release lift cylinder (6) from mounting bracket (11). Remove
two bolts (19), lockwashers (20), plate (21) and spacers (22) from each side of frame assembly (2). Discard lockwash-
ers.
20.
Remove pin assembly (23) from frame assembly (2) that attaches lift cylinder (6) to mounting bracket (11).
21.
Remove grease fitting (24) from each end of pin assembly (23), if required.
22.
Remove lift cylinder (6) from frame assembly (2).
23.
Repeat steps 19 through 22 for other lift cylinder (6).
13
12
1
18
6
6
11
12
20
16
17
23
2
22 21
19
386-581
24
14 15
24.
Use a suitable lifting device to remove frame assembly (2) from back of tractor.
0173 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals