BLADE CUTTING EDGE AND END BITS REPLACEMENT

TM 5-2410-233-23

BLADE CUTTING EDGE AND END BITS REPLACEMENT

0169 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Materials/Parts

Tools and Special Tools

Wood cribbing, 4 in. x 4 in. x 12 in. long

Tool kit, general mechanic's (Item 112, WP 0185

Personnel Required

Shop equipment, common no. 2 (Item 95, WP 0185

Three

Equipment Condition

Machine parked on level ground (TM 5-2410-233-

10)

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.

NOTE

Left side end bit weighs 39 lb (18 kg).

Right side end bit weighs 41 lb (19 kg).

Cutting edge weighs 275 lb (125 kg).

REMOVAL

Raise blade approximately 12 in. (30.5 cm) and block right and left pusharms securely at blade end.

Shut off engine.