REMOVAL - TM-5-2410-233-230776

TM 5-2410-233-23

HYDRAULIC SYSTEM LINES AND FITTINGS REPLACEMENT - CONTINUED

0160 00

REMOVAL

CAUTION

Keep work area clean. Wipe area clean around all hydraulic fittings and couplings. Cap or plug openings to

prevent contamination of hydraulic system, which could result in premature failure.

NOTE

Tag all hydraulic tubes and hoses to ensure correct installation.

Use a suitable container to capture any oil leakage. Dispose of oil IAW local policy and ordi-

nances. Ensure all spills are cleaned up.

Mounting hardware (nuts, bolts, washers, lockwashers and spacers) will vary depending on

type and location of clamp, clip or retaining strap.

Tube Assembly with Split-Flanged Mounting.

Remove clamps (1), clips (2) and/or retaining straps (3) along entire length of tube assembly (4) as follows:

(1)

Clamp. Remove nut (5), lockwasher (6), bolt (7), washer (8) and clamp (1). Discard lockwasher.

(2)

Clip. Remove nut (9), lockwasher (10), bolt (11) and clip (2). Discard lockwasher.

(3)

Retaining strap. Remove bolt (12), lockwasher (13), spacer (14) and retaining strap (3). Discard lock-

washer.

Remove four capscrews (15), lockwashers (16), two flanges (17), tube assembly (4) and O-ring (18). Discard lock-

washers and O-ring.

c. Repeat step b for other end of tube assembly (4) and remove tube assembly.

Tube or Hose Assembly Connected to Adapter.

Remove clamps (1), clips (2) and/or retaining straps (3) along entire length of tube or hose assembly (19) as speci-

fied in step 1a above.

b. Use two wrenches to disconnect tube or hose assembly (19) from adapter (20).

c. Remove O-ring (21) and adapter (20). Discard O-ring.

d. Repeat steps b and c for other end of tube or hose assembly (19) and remove tube or hose assembly.

Tube or Hose Assembly Connected to Elbow.

Remove clamps (1), clips (2) and/or retaining straps (3) along entire length of tube or hose assembly (22) as speci-

fied in step 1a above.

Use two wrenches to disconnect tube or hose assembly (22) from elbow (23).

Remove elbow (23) and O-ring (24). Discard O-ring.

Repeat steps b and c for other end of tube or hose assembly (22) and remove tube or hose assembly.

0160 00-2