 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
BLADE TILT CYLINDER REPLACEMENT - CONTINUED
0154 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Tilt cylinder weighs 418 lb (190 kg).
1.
Attach a nylon sling and a suitable lifting device to center of tilt cylinder (4).
2.
Position tilt cylinder (4) to bulldozer blade (18) and pusharm (17).
3.
Install tilt cylinder (4) and ball joint sockets (12 and 14) at blade end with four capcrews (10). Do NOT install
lockwashers (11) or shims (13).
NOTE
Push or pull tilt cylinder as needed to line up cylinder with pusharm.
4.
Position tilt cylinder (4) on pusharm (17) and install pin (16) and new cotter pin (15).
13
10,11
12
14
18
4
15
16
4
17
386-804
386-803
0154 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals