ADJUSTMENT - TM-5-2410-233-230674

TM 5-2410-233-23

WINCH CONTROL LEVERS AND LINKAGE ADJUSTMENT - CONTINUED

0141 00

ADJUSTMENT - CONTINUED

Completely loosen two nuts (9) from brake and winch cable rod ends (7) at clevises (10) in control bracket (5).

NOTE

Both cable rod ends may need to be removed from clevises to turn other end of cable rod to specification.

At winch end, adjust both control cable rod ends (7) evenly so when threading rod ends into brake and winch control

valves measurement is 0.50 in. (13 mm) in length.

NOTE

Measurement from top of threads on control cable to clevis is 3/4 in. (19 mm).

At winch control lever end, thread both control cable rod ends (7) evenly into brake and winch control clevises (10).

Position winch control lever centered in neutral position.

NOTE

Adjustment procedure for brake and winch cables is done in the same manner.

Both cables are turned evenly from either end in 1/2 turn increments.

If winch control lever will not position in neutral, adjust control cable rod ends (7) evenly until lever is in neutral posi-

tion.

Measure distance between knob of winch brake lever and knob of winch control lever in neutral position. Adjustment

between two levers is 7 in. (18 cm).

10.

Tighten two nuts (9) to secure cable rod ends (7) to clevises (10).

386-092

386-088

0141 00-2