STEERING BRAKE DRUM, BRAKE PEDALS AND PARKING BRAKE LEVER ADJUSTMENT

TM 5-2410-233-23

STEERING BRAKE DRUM, BRAKE PEDALS AND PARKING BRAKE LEVER ADJUSTMENT

THIS WORK PACKAGE COVERS

Adjustment

INITIAL SETUP

Equipment Condition

Tools and Special Tools

Battery disconnect switch in OFF position (TM 5-

Tool kit, general mechanic's (Item 112, WP 0185

2410-233-10)

Floor plates removed (WP 0135 00)

Materials/Parts

Gasket (4)

Lockwasher (2)

Pin, cotter (9)

NOTE

Perform all adjustment steps in this procedure to properly adjust steering brakes.

Ensure all linkage mounting bolts are tight before performing adjustment.

ADJUSTMENT

NOTE

The following procedure is for brake drum adjustment. Perform adjustment on both sides.

Remove three bolts (1) and lockwashers (2) from cover (3). Discard lockwashers.

Remove cover (3) and gasket (4) from top of steering clutch and final drive top cover (5) to gain access to brake band

adjusting screw (6). Discard gasket.

Turn brake band adjusting screw (6) to the right until band is tight, then loosen screw 1-1/2 turns (9 clicks) to the left.

Install new gasket (4) and cover (3) with three new lockwashers (2) and bolts (1).

1,2

3,4

386-400