 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
STEERING BRAKE PEDALS AND LINKAGE MAINTENANCE - CONTINUED
0121 00
DISASSEMBLY - CONTINUED
3.
Remove bearing (31) from bellcrank (11).
31
11
386-425
CLEANING
1.
Wipe bearing surfaces of bellcranks and foot pedals clean and dry.
ASSEMBLY
NOTE
Lightly coat bearing surfaces and bearings with grease before installation. After installation,
remove excess grease with a rag.
Only one rod, brake pedal and bellcrank are shown. Procedures for assembly are the same for
all others.
1.
Install bearing (31) into bellcrank (11).
2.
Install two bearings (30) in foot pedal (4).
3.
Install two nuts (28) on each end of rod (29).
4.
Install two rod ends (7) on each end of rod (29). Adjust rod ends to a distance of 19.25 in. (48.90 cm) between center
lines of holes in rod ends.
5.
Tighten two nuts (28) against rod ends (7) to 75 lb-ft (102 Nm).
7
28
4
28
7
30
30
29
386-423
386-424
0121 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals