 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRACK DRIVE SPROCKETS/HUBS REPLACEMENT - CONTINUED
0118 00
REMOVAL - CONTINUED
16.
Unbend tabs of retainer lock (28).
17.
Loosen nut (29) until there is a 1 in. (25.4 mm) gap
between nut and sprocket (27).
18.
Turn nut (29) toward sprocket (27) until remover tool
28
can be inserted between nut and bearing (30).
29
CAUTION
30
Use care when removing bearing and nut. Haste
or improper choice of removal tool will damage
parts.
19.
Turn nut (29) away from sprocket (27) and remove
bearing (30).
20.
Remove removal tool, nut (29) and retainer lock (28).
Discard retainer lock.
27
386-280
21.
Install an adapter (31) on drive hub and turn to within
0.25 in. (6.3 mm) of sprocket (27).
22.
Install three adapters (32) in three puller holes in
33
sprocket (27).
23.
Install three nuts (33) on adapters (32) with angle side
toward sprocket (27) and flat side even with threaded
32
end of adapter (31). Position drill point on nut toward
outer edge of sprocket.
27
31
386-281
0118 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals