 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRACK IDLER YOKE REPLACEMENT - CONTINUED
0116 00
REMOVAL - CONTINUED
3.
Strike rod (9) inside center of yoke (8) to break rod
9
taper loose and free yoke. Pull yoke away from rod.
WARNING
Use extreme caution when handling heavy
parts. Provide adequate support and use assis-
tance during procedure. Ensure that any lifting
device used is in good condition and of suitable
load capacity. Keep clear of heavy parts sup-
8
ported only by lifting device. Failure to follow
386-267
this warning may cause injury or death.
NOTE
Yoke weighs 110 lb (50 kg).
4.
Use a nylon sling and a suitable lifting device to raise open end of yoke (8) and remove four plates (10), springs (11) and
two plate assemblies (12).
5.
Remove yoke (8) with lifting device.
INSTALLATION
1.
Position two plate assemblies (12) on track roller frame (5).
2.
Install two springs (11) and plates (10) on each plate assembly (12).
10
11
8
386-268
5
12
11
10
386-269
12
0116 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals